(anonymous IP: 18.119.167.189,353) | ||||||||||||||
| ||||||||||||||
Audio (97) Datatype (15) Demo (50) Development (247) Document (63) Driver (19) Emulation (62) Game (529) Graphics (224) Library (22) Network (62) Office (21) Utility (250) Video (18) Total files: 1679 Full index file Recent index file Part of aros exec |
[Show comments] [Show snapshots] [Show videos] [Show content] [Replace file] HVL2WAV 1.1 =========== By Xeron/IRIS (pete()petergordon.org.uk) Web: http://www.hivelytracker.com hvl2wav converts hivelytracker modules to standard wave files to enable you to listen to them wherever there is no hivelytracker replayer (and also so you can edit or reencode them to something else). The simplest way to use it is just: hvl2wav filename.hvl which will output "filename.wav" as a 44100hz stereo wav file. You can also specify the following options: -ofilename This will output to 'filename' instead of just putting ".wav" at the end of the input filename. -tm:ss Timeout after m minutes and ss seconds. If you don't specify the -t option, hvl2wav will stop either when the song ends, or at 10:00, whichever comes first. Specifying "-t" disables the song end detection and sets the length of the output file. This is especially handy for AHX or HVL songs that loop; you can specify a time that will let them loop 2 or 3 times and then fade it out in a sample editor. -fn Sets the frequency to n Hz. By default it generates a 44100Hz file. With -f you can set it anywhere between 8000 and 48000hz. -sn Use subsong n. By default it just uses the main song (0). Not all hivelytracker or ahx files have subsongs. -a Calculates optimal gain before converting. This makes the output file as loud as possible without clipping, but it does it at the mixing stage, so its a lot better quality than if you loaded the output wav file and maximised it. A lot of HVL songs will already have the optimal gain value in the module (the composer can manually set it, or perform this same calculation before saving a hivelytracker module), but AHX songs don't have any concept of gain since they rely on paula to do the mixing, and so this is probably more useful when converting ahx files than hvl (although it does no harm to specify it always if you wish). -xn This specifies the stereo seperation for AHX files (it has no effect on HVL files since they override it with their own panning). n can be set to one of 5 values: 0 = 0% (Mono) 1 = 25% 2 = 50% 3 = 75% 4 = 100% (Paula) |
Copyright © 2005 - 2024 The AROS Archives All Rights Reserved |